COLD PAINT APPLICATION EQUIPMENT
The Borum Master 3000 series provides you with a variety of high capacity line marking machines designed for medium to large scale jobs such as marking highways, motorways or airport runways.
The material tank capacity can be of 440 L or alternatively, 2 x 440 L. The possibility for the large material capacity naturally gives fewer stops during the day for refilling.
The BM 3000 has a two-seat slidable drive and operator section for flexible working on the left or right side.
With the Borum BM C6 paint gun that has a nozzle of 6 mm you can apply line widths ranging from 8 to 20 cm depending on work conditions, application speed, and layer thickness. The machine can be equipped with up to three paint guns and 3 glass beads gun as standard.
The equipment may be used for the application of single and double lines of different widths, as well as for simultaneous application of continuous and interrupted lines.
Line types that can be applied with this equipment
Pressurized black steel tank for water-based cold paint.
The material tank has a filling system with large filling holes. This makes the filling process very easy to manage. In addition, the large filling holes also make cleaning the tanks easy.
Agitator (mixer) driven by hydraulic motor and with manually operated reversing valve.
Air spray with atomizing air is a method of marking that uses compressed air to spray the paint onto the road surface. The pressure is established by using a pressure tank for the material. The paint can be mixed with glass beads.
For all Borum spray machines, the equipment is mounted on a sliding retainer frame as standard that allows you to quickly slide the equipment from one side to another. You can have 1-3 paint guns and 1-3 bead guns are attached.
The ground distance is maintained by a retainer wheel to ensure a constant road marking width. Lifting of retainer is done from the operator's seat.
Paint filter with cut-off valve for easy maintenance.
The machine can be equipped with two material tanks so that dual-color marking can be carried out simultaneously.
Working speed can be up to 15 km/h depending on the conditions, e.g. material, line type, and operator experience
High-performance spray gun. with a 6 mm nozzle set for water-based, solvent-based and high solid paints. The BM C 6 gun can work with paint marking pressure up to approx. 8 bar.
Air capacity of 300-700 L/min. is needed per gun.
Possibility to apply lines in widths from 8 to 20 cm with one gun depending on work conditions, application speed, and layer thickness. Line thickness is typically between 0.25 mm to 0.80 mm.
Cold paint material is a cost-effective solution for executing flat markings over all types of pavements and for use in repairments. Flat lines are mainly used in well-illuminated areas as urban roads for e.g. where the lines do not need high retroreflectivity levels. Although drying time different between types of paints, it is usually quite long and cones and traffic management might be needed.
10L pressure solvent tank for cleaning of hoses and paint guns.
The Borum LineMaster control unit is an easy way of setting and controlling your line marking jobs. The LineMaster is attached to the operator's section of the machine and gives you full control of all your line marking tasks, from line application and pre-marking to reporting and invoicing.
It is possible to store up to 99 different line types, and to arrange these in up to 30 different marking programs. You are also able to pre-set line widths, line types, colours and combinations to have them ready for marking, and can instantly adjust them on the go.
Furthermore, you are able to view the status of various parts of the machine (e.g. compressor) on the computer screen that will help with correctly maintaining the machine and avoiding break downs.