COLD PAINT APPLICATION
The Borum® Master 5000 series provides you with a variety of high capacity line marking machines designed for large scale jobs such as marking highways, motorways or airport runways.
The material tank capacity can be either 2 x 440L or 1 x 1000L. The possibility of the large material capacity naturally gives fewer stops during the day for refilling.
The BM 5000 has a two-seat slidable drive and operator section for flexible working on left or right side.
The Borum cold paint application equipment can be set to execute lines in widths of 8-100 cm and with multiple colours. The equipment may be used for the application of single and double lines of different widths, as well as for simultaneous application of continuous and intermittent lines.
Line types that can be applied with this equipment
Pressurised material tank and filters in stainless steel for water and ammonium based paints.
Dual stroke high pressure airless pump.
Capacity: Up to 24 litres/min (6,5 gal/min)
Max pressure: 270 bar (3915 psi).
Reduced valve strokes for optimal handling of paint pressurised material tank and filters in stainless steel for water and ammonium based paints.
For all Borum spray machines, the equipment is mounted on a sliding retainer frame as standard that allows you to quickly slide the equipment from one side to another. You can have 1-3 paint guns and 1-3 bead guns are attached.
Ground distance is maintained by retainer wheel to ensure a constant road marking width.
Lifting of retainer is done from operators seat. Pneumatic cylinder, foundation and pneumatic solenoid valve.
Paint filter with cut-off valve for easy maintenance.
Can be equipped with multiple material tanks, so that multi-color marking can be carried out simultaneously.
Working speed can be up to 15 km/h depending on the conditions, e.g. material, line type and operator experience
High-performance spray gun. 6 mm nozzle set for water based, solvent based and high solid paints. The BM C 6 gun can work with paint marking pressure up to approx. 8 bar.
An air capacity of 300-700 L/min. is needed per gun.
Possibility to apply lines in widths from 8 to 20 cm with one gun depending on work conditions, application speed, and layer thickness. Line thickness is typically between 0.25 mm to 0.80 mm
Cold paint material is a cost effective solution for executing flat markings over all types of pavements and for use in repairments. The Borum cold paint application equipment can accommodate any type of line marking job as it can be set to execute lines in widths of 8-100 cm. Furthermore, depending on the choice of material tanks, it is possible to apply lines in different colours in the same time.
10L pressure solvent tank for cleaning of hoses and paint guns.
The Borum LineMaster allows you efficient control of all line marking tasks, from line application and pre-marking to reporting and invoicing. It is possible to store up to 99 different line types, and to arrange these in up to 30 different marking programs. You are also able to pre-set line widths, line types, colours and combinations to have them ready for marking, and can instantly adjust them on the go.