COLD PAINT AIRLESS APPLICATION
From city areas to urban and interurban roads, the Borum® Master 2000 can handle both smaller jobs and longer road stretches.
The BM 2000 CA is an agile machine with excellent load abilities and a turning radius of only 3.2 m. It allows for paint tank capacities of 440 L or 2 x 220 L for two colors.
The BM 2000 has a one-seat slidable drive and operator section for flexible working on the left or right side.
The application equipment can be set to execute lines in widths of 8-100 cm and with multiple colours. The equipment may be used for the application of single and double lines of different widths, as well as for simultaneous application of continuous and intermittent lines.
Line types that can be applied with this equipment
Pressurised material tank and filters in stainless steel for water and ammonium based paints.
Dual stroke high pressure airless pump.
Capacity: Up to 24 litres/min (6,5 gal/min)
Max pressure: 270 bar (3915 psi).
Reduced valve strokes for optimal handling of paint pressurised material tank and filters in stainless steel for water and ammonium based paints.
The gear pump SP 2000 is especially used for jobs with big lifting height, or long material pipe.
The gear pump is operated by a hydraulic motor. Pump and material pipes are heated by heat transmission oil, which is
circulated by a hydraulically driven pump.
Max capacity is 120 L/min when fed with 30 L/min. hydraulic oil flow.
For the SP 2000 a motor driven PTO can be used for driving a hydraulic pump. An electrically operated control valve govern the gear pump speed.
With this arrangement remote operation of the pump system can easily be performed.
Sliding retainer frame, upon which 1-3 paint guns and 1-3 bead guns are attached. Easily slideable from side to side for an optimal working position.
Ground distance is maintained by retainer wheel to ensure a constant road marking width.
Lifting of retainer is done from operators seat.
Pneumatic cylinder, foundation and pneumatic solenoid valve.
Paint filter with cut-off valve for easy maintenance.
With one way valve allowing up to 8 hose connections (1 return hose, 5 paint guns and 1 hand paint gun). All hoses are of big dimensions to minimize the pressure loss giving an optimal result on the road.
Automatic high-performance spray gun. Nozzle set for water based, solvent based and high solid paints. Possibility to apply road marking in widths from 8-100cm (3-40 in) depending on the number of spray guns and nozzles.
High pressure filter unit with integrated pulsation damper. Easy cleaning and maintenance.
Cold paint material is a cost effective solution for executing flat markings over asphalt pavements and for use in repairments. The Borum cold paint application equipment can accomodate any type of line marking job as it can be set to execute lines in widths of 8-100 cm. Furthermore, depending on the choice of material tanks and additional pump, it is possible to apply lines in different colours at the same time.
10L pressure solvent tank for cleaning of hoses and paint guns.
The Borum LineMaster allows you efficient control of all line marking tasks, from line application and pre-marking to reporting and invoicing. It is possible to store up to 99 different line types, and to arrange these in up to 30 different marking programs. You are also able to pre-set line widths, line types, colours and combinations to have them ready for marking, and can instantly adjust them on the go.